Stand Assembling; Stand Attaching To The Plasma Display - Pioneer PDP-433CMX Technical Manual

Tabletop Stand: PDK-TS01

4.5.4 Stand assembling

1) Assembling Steps
1 Turn the base cover over so the underside is facing up.
2 Insert the stand pipes into the base cover.
3 Use the included screws to stabilize the stand pipes.
Screws (4 × 8)
Stand pipe

4.5.5 Stand attaching to the Plasma Display

1) Normal Installation
1 With the plasma display lying flat, insert and secure the two Installation bolts 1 (M8 × 20) in the holes "a" located in
the plasma display housing.
At this point, tighten these bolts 1 only until the threads are no longer visible when viewed from t he side (you will
be unable to attach the display if the bolts are screwed in completely).
Plasma display
76
Base cover
Installation bolt 1 (M8 × 20)
Holes "a"
[503CMX/503MXE : 433CMX/433MXE]
Installation bolt 1
Screws (4 × 8)
Stand pipe
Plasma display housing
Stop screwing down the
bolt when the threads are
no longer visible.