Normal Operating Mode; About Normal Operating Mode - Pioneer PDP-433CMX Technical Manual

5.2 Normal Operating Mode

5.2.1 About normal operating mode

Normal operating mode enables the following:
1 Input switching
• Pressing one of the INPUT buttons, 1 to 5
• Pressing the INPUT button on the operating panel of the main unit
2 Screen-size switching
• Repeated pressing the SCREEN SIZE button on the remote control or the operating panel of the main unit changes
screen size in the following sequence:
When reproducing video signals (signals other than PC signals) # (applies only when equipped with PDA-5002)
= WIDE = 4 : 3 = FULL = ZOOM =
When reproducing PC signals
= DOT BY DOT = 4 : 3 = FULL = PARTIAL (Compatible only with PDP-503CMX/PDP-503MXE) =
(NOTES) • The screen size at which playback can be performed differs according to the input signal.
See 5.1.3, "List of supported input signals".
Displays with "(TYPE)" appended, such as FULL (TYPE), will sometimes appear, indicating a simplified
reproduction.
• If an HDTV signal is detected, the screen size will switch to FULL (fixed). # (applies only when equipped
with PDA-5002)
• During video playback, switching screen size to ZOOM or PARTIAL (Compatible only with PDP-503CMX/
PDP-503MXE) permits scrolling the screen up or down with the 5 and ∞ buttons (V-SCROLL function).
Refer to section 5.1.4, "List of adjustable and settable items".
You will note that the act of reduction, enlargement, etc. of the screen using the screen size changing
function of this machine at a coffee shop, hotel, etc. for profit or for public view may result in infringement
of the right of an author protected under the Copyright Law.
3 Display call
A Press the DISPLAY button on the remote control.
= The current input function, the incoming signal's horizontal and vertical frequencies, current screen size, and
other characteristics are displayed on the screen.
(NOTE) The displayed horizontal and vertical frequencies are measured values, and there may be some error in the
measurements.
B Push and hold the DISPLAY button on the remote control or the operating panel of the main unit for two or more
seconds while A is displayed.
= The various settings, internal temperature, etc. are displayed as shown on the screen below.
P OWE R
POWE R
O F F T I ME R
O R B I T E
M A S K
2 X 2 M DE
T E P ERA T UR E M
H OUR ME T E R
I D NO S E T
I NPUT 1
P L A SMA
C O N T R O L : S T AN D AR
M ANAG ME E N T : O N
: 2 / 0 . 5 / W
R M DE O : O F F
C O N T R O L : OF F
O : OF F / U L
: C
: 0 0 0 2 7 H
. : – –
=
Input switches over to the selected input.
=
This switches the input to the next input.
D
H
F U L L
Normal Operating Mode
131