Displaying Cumulative Play/On Time; Returning Main Unit Settings To Default Values - Pioneer DVD-V8000 Operating Instructions Manual

07 Function for Commercial Use
Displaying cumulative
Play/ON Time
This player is provided with a run-time meter to allow the
display of cumulative play-time and cumulative on-time for
purposes of understanding operating conditions and mainte-
nance times. The cumulative play/on time can be displayed
as follows:
1. While depressing the main unit's
DISPLAY button, press the STANDBY/ON
button to turn on power.
The screen and main unit display will show the following
message.
When resetting is performed during maintenance, the fig-
ures within brackets [ ] will be reset to [0].
[Screen display example]
[Main unit display example]
In these examples, the cumulative on-time is recorded as
109 hours and 37 minutes, and the cumulative play-time
is recorded as 56 hours and 58 minutes.
Also, following a maintenance reset, the cumulative on-
time will be displayed as 25 hours and 20 minutes, the
cumlative-play time will be displayed as 2 hours, 25 min-
utes.
2. When any other operation (e.g., pressing
the remote control unit's PLAY button) is
performed, the cumulative play/on time
display disappears and normal operation
resumes.
78
Important
¶ These run-time calculations are performed based on the
CPU's clock, with the result that accuracy may involve a
deviation of 2 %.
¶ The metered time cannot be reset to [0].
Setting the internal clock
The DVD-V8000 is equipped with an internal clock allowing
the use of timer functions to perform automatic playback/
stop.
Setting of the internal clock is performed by the [WEEKLY
TIMER] item on the ADV. SETUP menu. For details, see page
57, "WEEKLY TIMER Setting".
Important
¶ The internal clock has a deviation within approximately
2 minutes per month (depending on environmental con-
ditions).
¶ The internal clock function operates by a large-volume
capacitor. So long as the power cord is connected to a
power outlet, the clock function will operate, even when
in standby mode. If the power cord is disconnected,
the clock function will continue to operate for 7 to 10
days (when fully charged, at 25 °C).
¶ WEEKLY TIMER setting data is preserved even if the
power cord is disconnected for an extended period of
time, regardless of the clock setting.
Returning main unit settings
to default values
The main unit settings can be returned to their factory de-
faults in the following way:
1. Set the player to standby mode.
2. While depressing the SCAN/STEP 1 4
button, press the STANDBY/ON button;
power will turn ON and all settings will
be reset to their factory default values.
Note
¶ Previously input Command Stack and play/power on time
data are not deleted even when settings are returned to
their default values.