Network Config Page - Panasonic PT-D10000 Operating Instructions Manual

How to use network function (continued)
■
Adjust clock page
Click [Network set up], then [Adjust clock] to display the Adjust clock page.
Note
• If the time becomes incorrect immediately after setting the correct time, then the battery needs to be changed.
Contact the dealer where you bought the projector to have the battery changed.
■

Network config page

Click [Network set up], then [Network config] to display the Network config page.
96
– ENGLISH
Time zone selection Time zone selection
Button to update time zone setting Button to update time zone setting
New date field New date field
Button to update time and date Button to update time and date
settings settings
New time field New time field
Set this to ON to enable the DHCP Set this to ON to enable the DHCP
client function. client function.
Enter the IP address if DHCP server Enter the IP address if DHCP server
is not used. is not used.
Enter the port number here. Number Enter the port number here. Number
80 is normally used. 80 is normally used.
Enter the net mask if DHCP server is Enter the net mask if DHCP server is
not used. not used.
Enter the gateway address if DHCP Enter the gateway address if DHCP
server is not used. server is not used.
Enter the name of the projector Enter the name of the projector
here. Enter the host name here if it here. Enter the host name here if it
is required when the DHCP server is is required when the DHCP server is
going to be used, for instance. going to be used, for instance.