Panasonic PT-D10000 Operating Instructions Manual page 62

How to use ADVANCED MENU (continued)
Note
• The abovementioned vertical stripes will not appear
on the screen when all signals are input.
• The picture may be distorted during the adjusting
operation, but this is not a fault.
• The input resolution can be adjusted only when
RGB signal input is applied with RGB1 and RGB2
IN.
Adjusting the clamp
position
Use the clamp position adjustment to achieve the
optimal value when dark areas of the image are
crushed or displayed in green.
1. Press ▲▼ to select "CLAMP
POSITION".
ADVANCED MENU ADVANCED MENU
DIGITAL CINEMA REALITY DIGITAL CINEMA REALITY
BLANKING BLANKING
INPUT RESOLUTION INPUT RESOLUTION
CLAMP POSITION CLAMP POSITION
EDGE BLENDING EDGE BLENDING
FRAME DELAY FRAME DELAY
RASTER POSITION RASTER POSITION
MENU SELECT MENU SELECT
SUB MENU SUB MENU
ENTER ENTER
2. Press ENTER.
• The "CLAMP POSITION" screen will be
displayed.
CLAMP POSITION CLAMP POSITION
POSITION POSITION
MENU SELECT MENU SELECT
ADJUST ADJUST
3. Press ◄► to adjust.
• The value changes from 1 to 255.
• The optimal value for the clamp position
adjustment
If dark areas are crushed:
The optimal value is the point where the dark
area is best improved.
If the dark areas are displayed in green:
The optimal value is the point where the green
area becomes dark and clear.
Note
• The clamp position can be adjusted only when the
RGB signal input is applied with RGB1 and RGB2
IN.
62
– ENGLISH
AUTO AUTO
OFF OFF
DEFAULT DEFAULT
1 1
Edge blending adjustment
This projector has the function to hide the seams for
multi-screens.
1. Press ▲▼ to select "EDGE
BLENDING".
ADVANCED MENU ADVANCED MENU
DIGITAL CINEMA REALITY DIGITAL CINEMA REALITY
BLANKING BLANKING
INPUT RESOLUTION INPUT RESOLUTION
CLAMP POSITION CLAMP POSITION
EDGE BLENDING EDGE BLENDING
FRAME DELAY FRAME DELAY
RASTER POSITION RASTER POSITION
MENU SELECT MENU SELECT
CHANGE CHANGE
2. Press ◄► to switch "EDGE
BLENDING".
• The setting will change as follows each time
◄► is pressed.
OFF OFF
• OFF:
When the multi-screens are not going to be
used.
• ON:
When the tilting inside the unit is to be used for
the tilting of the edge blending area.
• USER:
When a specific tilting is to be used for the
tilting of the edge blending area. (Separate
software is required to establish these settings.
Consult your dealer.)
3. Press ENTER.
• The "EDGE BLENDING" screen will be
displayed.
EDGE BLENDING EDGE BLENDING
UPPER UPPER START START
OFF OFF WIDTH WIDTH
LOWER LOWER START START
OFF OFF WIDTH WIDTH
LEFT LEFT START START
OFF OFF WIDTH WIDTH
RIGHT RIGHT START START
OFF OFF WIDTH WIDTH
MARKER MARKER
BRIGHT ADJUST BRIGHT ADJUST
MENU SELECT MENU SELECT
ADJUST ADJUST
ENTER ENTER
AUTO AUTO
OFF OFF
DEFAULT DEFAULT
ON ON USER USER
0 0
128 128
0 0
128 128
0 0
128 128
0 0
128 128
OFF OFF
CHANGE CHANGE