Setting the date and time
This function lets you set the date and time. The date and time is saved
with each picture, and is used in the file name.
1
Press [\ to select one of the
following date formats: [Y-M-D]
(Year/Month/Day), [M-D-Y]
(Month/Day/Year), [D-M-Y] (Day/
Month/Year), and press ] .
• Move to the year setting.
• The following steps show the procedure
used when the date and time settings
are set to [Y-M-D].
2
5
Press [\ to set the year, then
press ] to move to the month
setting.
• To move back to the previous setting,
press ^.
• The first two digits of the year are fixed.
3
Repeat this procedure until the
date and time are completely set.
• The time is displayed in the 24-hour
format. Consequently, 2 p.m. is displayed as 14:00.
4
Press i.
• For a more accurate setting, press i when the time signal hits 00 seconds.
• Press j to exit the menu.
Note
• The date and time settings will be returned to the factory default settings if the
camera is left without batteries for approximately 3 days. The settings will be
canceled more quickly if the batteries were only loaded in the camera for a
short time before being removed. Before taking important pictures, check that
the date and time settings are correct.
• If the date and time setting is canceled, a warning is displayed on the monitor
the next time the camera is turned on. g"Error codes" (P. 89)
52
j
i
[X]
g"How to use the menus" (P. 15)
2005
Y
SELECT
2005
SELECT
X
M
D
SET
GO
X
SET
GO