Connecting The Antenna Terminals - Marantz SR9600 User Manual

CONNECTING THE ANTENNA TERMINALS

AM EXTERNAL
AM LOOP ANTENNA
ANTENNA
7.1CH IN MAIN IN
L SL SBL C L R SL SR
DIGITAL
IN
(AUDIO)
1
S400
2 R SR SBR SW PRE OUT
(AUX 2)
L
3
AUDIO
S400
R
4
TUNER-1
DVD LD TV DSS VCR-1 VCR-2 / DVD-R
IN OUT IN
5
AM GND
VIDEO
6
S-VIDEO
7
INPUT-1 INPUT-2
(DVD) (DSS)
HDMI
8 Ver 1.1
TUNER-2
INPUT-1 (DVD) INPUT-2 (DSS) INPUT-3 (VCR-1)
AM GND
COMPONENT
C B / C R / C B / C R / C B /
OPT VIDEO Y P P Y P P Y P
B R B R B
1 3 1 3
FLASHER RECEIVER
COAX
IN
2 4 2 4
DIGITAL
OUT
USB AUDIO RS232C DC OUT EMITTER OUT
ASSEMBLING THE AM LOOP ANTENNA
1.
Release the vinyl tie and take out the connection
line.
2.
Bend the base part in the reverse direction.
3.
Insert the hook at the bottom of the loop part
into the slot at the base part.
26
FM EXTERNAL
FM FEEDER ANTENNA
ANTENNA
ANTENNA
SPLITTER
MULTI OUT
SBL SBR C A B
L
FRONT A
CENTER
LEFT
R
SPEAKER C
SW AUDIO
ON
SURR.BACK
/MULTI SPK. FRONT A
OFF
/SPK. C
RIGHT
LEFT
SURR.BACK FRONT B
/MULTI SPK.
LEFT
/SPK. C
RIGHT
IN TAPE OUT IN CD-R / MD OUT CD
MONITOR OUT TUNER-1 TUNER-1
OUT 1 2
AM AM GND GND FM(75Ω) FM(75Ω)
FRONT B
RIGHT
MULTI OUT
A B
TUNER-2 TUNER-2
SURR.
AM AM GND GND FM(75Ω) FM(75Ω)
VIDEO LEFT
OUTPUT
Y C B / C R /
P B P R
OUTPUT-1
SURR.
INPUT-4 (VCR-2 / DVD-R) RIGHT
CLASS 2 WIRING
SPEAKER SYSTEMS
SWITCHED 1A 120W MAX
FRONT A OR B, CENTER, SURR,
SURR BACK : MINIMUM 6 OHMS
FRONT A AND B : MINIMUM 8 OHMS
C R / C B / C R /
P Y P P OUTPUT-2
R B R
UNSWITCHED 1A 120W MAX
IN MODEL NO. SR9600
IR
AC IN
IN
OUT
AC 120V 60H Z
RC-5 MULTI RC
AC OUTLETS
4.
Place the antenna on a stable surface.
CONNECTING THE ANTENNA WIRE TO THE
ANTENNA CONVERTER
Loosen the screws and attach the wire terminals,
then tighten the screws with a screwdriver.
CONNECTING THE SUPPLIED ANTENNAS
Connecting the supplied FM antenna
The supplied FM antenna is for indoor use only.
During use, extend the antenna and move it in
various directions until the clearest signal is
received.
Fix it with push pins or similar implements in the
position that will cause the least amount of
distortion.
If you experience poor reception quality, an
outdoor antenna may improve the quality.
Connecting the supplied AM loop antenna
The supplied AM loop antenna is for indoor use
only.
Set it in the direction and position it to where you
receive the clearest sound. Put it as far away as
possible from the unit, TVs, speaker cable, and
power cord.
If you experience poor reception quality, an outdoor
antenna may improve the quality.
1.
Press and hold down the lever on the AM antenna
terminal.
2.
Insert the bare wire into the antenna terminal.
3.
Release the lever.
Note:
• Connect the shielded grounding wire (black) to the
AM antenna GND terminal.
CONNECTING AN FM OUTDOOR ANTENNA
Notes:
• Keep the antenna away from noise sources (neon
signs, busy roads, etc.).
• Do not put the antenna close to power lines. Keep
it well away from power lines, transformers, etc.
• To avoid the risk of lightning and electrical shock,
grounding is necessary.
CONNECTING AN AM OUTDOOR ANTENNA
An outdoor antenna will be more effective if it is
stretched horizontally above a window or outside.
Notes:
• Do not remove the AM loop antenna.
• To avoid the risk of lightning and electrical shock,
grounding is necessary.