MS-6702E ATX Mainboard
Chassis Intrusion Switch Connector: JCASE1
This connector is connected to a 2-pin chassis switch. If the chas-
sis is opened, the switch will be short. The system will record this
status and show a warning message on the screen. To clear the
warning, you must enter the BIOS utility and clear the record.
Power Saving Switch Connector: JGS1
Attach a power saving switch to this connector. Press the switch
once to have the system entered the Sleep/Suspend state. Press
the switch again to wake up the system.
D-Bracket™ 2 Connector: JLED (Optional)
The mainboard comes with a JLED connector for you to connect to D-Bracket™ 2. D-
Bracket™ 2 is a USB Bracket that supports both USB1.1 & 2.0 spec. It integrates four
LEDs and allows users to identify system problem through 16 various combinations
of LED signals.
2
1
JLED
Connected to JLED
Connected to JUSB1 or JUSB2 (the
USB pinheader in YELLOW color)
2-22
JLED Pin Definition
Pin
1
10
2
9
3
4
5
6
7
8
9
10
GND
CINTRU
JCASE1
JGS1
Signal
DBG1 (high for green color)
DBR1 (high for red color)
DBG2 (high for green color)
DBR2 (high for red color)
DBG3 (high for green color)
DBR3 (high for red color)
DBG4 (high for green color)
DBR4 (high for red color)
Key
NC
D-Bracket™ 2
(Optional)
2
1
LEDs