Routine Maintenance; Restoring Factory-Default Settings - Lexicon RV-8 User Manual

RV-8

ROUTINE MAINTENANCE

The bulleted items below describe routine maintenance that
should be performed on a periodic basis.
• Clean the RV-8 exterior surface with a soft, lint-free cloth. Do
not use alcohol, benzene, acetone-based cleaners or strong
commercial cleaners. Do not use a cloth made with steel wool
or metal polish. If the RV-8 is exposed to a dusty environment,
a low-pressure blower can be used to remove dust from its
exterior surface.
• Replace the remote control batteries as needed. The remote
control requires four AAA batteries. When these batteries are
low on power, the remote control enters a low-voltage condi-
tion that prevents it from operating the RV-8. When this
occurs, follow the instructions on page 1-6 to replace the bat-
teries. Normal operation will resume when new batteries are
installed.

RESTORING FACTORY-DEFAULT SETTINGS

When factory-default settings are restored, all parameters and
user-defined values are restored to their factory-default settings.
Before restoring factory-default settings, it is recommended tthat
you record all user-defined settings on the installation worksheet
that begins on page D-2.
FACTORY SETTINGS
EXIT
RESTORE DEFAULTS
RESTORE DEFAULTS
To restore factory-default settings:
1. Record all user-defined settings on the installation worksheet
that begins on page D-2. When factory-default settings are
Troubleshooting & Maintenance
restored, all parameters and user-defined values are restored to
their factory-default settings.
2. To ensure that the RV-8 remote control is in the correct mode
before proceeding, first press and release the HOME button.
Then, press and release the MAIN button.
3. If the RV-8 is powered on, press the front-panel standby
button or the remote control Off button to activate standby
mode and deactivate the RV-8. If the RV-8 is in standby mode,
proceed to step 3.
4. Press the front-panel standby button or the remote control On
button to deactivate standby mode and activate the RV-8.
FACTORY SETTINGS
EXIT
RESTORE DEFAULTS RESTORE DEFAULTS
5. Quickly press and hold the front-panel or remote control Mute
button until the FACTORY SETTINGS menu shown above
opens in the on-screen and front-panel displays.
The Mute button must be pressed within 2 seconds of
activating the RV-8. If the message "MUTE ON" appears in the
on-screen and front-panel displays when the Mute button is
pressed, too much time has passed. If this occurs, begin again
with step 2.
6. Press the remote control Menu
the desired option. Highlight the RESTORE DEFAULTS option to
FACTORY SETTINGS
HAVE BEEN RESTORED
PRESS ANY KEY
TO RESTART
and arrows to highlight
7-5