Kyocera KM-C2630D Operation Manual page 298

Section 10 MAINTENANCE AND OPERATION INFORMATION
NOTE
The message "Clean the slit glass for original fed from
DP." ["Clean the slit glass for original fed."] will appear
when the slit glass becomes dirty. Clean the slit glass as
described above, and then press the [End] key.
Inch specifications
Clean the slit glass for original fed from DP.
Metric specifications
Clean the slit glass for original fed.
10-2
1.Open the document processor
2.Clean the surface of the slit glass
located at left side with a dry cloth
3.Close the document processor
4.Press the END key
If the slit glass is dirty, black lines
might appear on the copy image
End
1.Open the document processor
2.Clean the surface of the slit glass
located at left side with a dry cloth
3.Close the document processor
4.Press the END key
If the slit glass is dirty, black lines
might appear on the copy image
End
Cleaning the resisting roller
Clean the resisting roller when you notice that the reverse sides of
your printed pages are soiled.
1
Grasping the paper conveyor unit handle, pull it out of the
copier.
2
Use the cleaning cloth that comes with the toner kit to
clean the metal resisting roller.
3
Push the paper conveyor unit back into the copier.