Misfeed In The Optional Document Processor - Kyocera KM-C2630D Operation Manual

Section 9 TROUBLESHOOTING

Misfeed in the optional Document Processor

The screens shown below indicate that there is a misfeed in the
Document Processor. At this time the original set indicator will
also flash red. Perform the following procedure to remove the
jammed paper.
Inch specifications
Paper misfeed.
JAM
Metric specifications
Paper misfeed.
JAM
1
Remove all of the originals remaining in the original table.
2
Remove all of the originals that have been ejected onto the
original eject.
9-16
1. Open document processor cover.
2. Lift up reversing unit.
3. Turn left dial.
4. Remove original paper.
5. Close the cover of document processor.
1. Open cover of document processor.
2. Lift reversing unit up.
3. Turn left dial.
4. Remove original paper.
5. Close cover of document processor.
3
Open the left cover of the Document Processor.
NOTE
When opening the cover, be sure to hold the handle in the
middle.
4
If there is an original jammed there, remove it while taking
care not to tear it.
NOTE
If the paper tears, remove all of the remaining pieces from
inside the Document Processor.
5
Open the paper reversing unit (1).
(1)