Datavideo RMC-120 User Manual page 10

selected on the Main Source bus is automatically
selected. If A+V is not engaged, the input source is user
selectable. Level controls for each input source are the
rotary pots below the selection buttons.
5. A+V: Audio follow video switch. When this button is
engaged (you'll know it is engaged because the LED is
lit), the audio associated with a selected input source
automatically follows the video through the
dissolve. When the button is inactive, audio
must be switched manually.
6. Color Processor: These controls become active in
conjunction with the Input Format selector (3.). When that
control is active, you can make adjustments to the
selected channel's brightness, contrast, color, and tint
(NTSC only) by pressing the up and down arrow buttons.
The LEDs on the left side of this section indicate relative
steps above or below unity (the signal exits the control
unchanged). Press and hold the Reset button in the
upper right for 2 seconds or more to reset the Color
Processor controls
all to unity. The
"Reset All" button
resets the color
correction and RGB
correction settings
for all 4 inputs.
9