Returning To Factory Default Setup - Intermec EasyCoder PF4i User Manual

Chapter 6—Setting Up the Printer

Returning to Factory Default Setup

There are two ways to return to the factory default setup of the printer:
Insert a special CompactFlash memory card and restart the printer.
A
Using the printer's built-in keyboard.
B
To reset the printer using the keyboard, do like this:
Lift the printhead.
1
Switch on the power to the printer and press the <i/F5> key and wait
2
until the printer beeps.
Swiftly press the following keys:
3
< /F4> < /F2>
The following message will be displayed:
4
Factory Default?
Enter=Yes ESC=No
Within 10 seconds, press <Enter> to reset the printer to factory
5
default. The parameters will be reset and the printer will continue the
normal startup.
If you press <Esc/F2> or wait until the 10 seconds timeout has passed,
the normal startup will continue without any reset being performed.
Note: If any of the fi les "card:NOSHELL.CFG",
rom:NOSHELL.CFG", or "c:NOSHELL.CFG" exists in the
printer's memory, no reset to factory default will be performed.
The factory default will remove all fi les used to store settings.
It will not reset settings that already has been read when the
fi les are removed. This means that EasyLAN Wireless settings
(SSID, keys, etc.) will retain their values from the previous
start. However, the next reboot will reset them to factory
default.
62
< /F2>
Intermec EasyCoder PF4i—User's Guide (Fingerprint version)
< /F1>