Magnifying And Searching For Details; Selecting The Aspect Ratio - InFocus IN102 Reference Manual

Magnifying and searching for details

If you need to look at specific details on the projected picture, magnify the picture.
Use the direction arrow keys for navigating the picture.
• Using the remote control
1. Press Digital Zoom +/- to display the
Zoom bar.
2. Press Digital Zoom + to magnify the
center of the picture. Press the key
repeatedly until the picture size is suitable
for your need.
3. Use the directional arrows ( ,
on the projector or remote control to
navigate the picture.
4. To restore the picture to its original size, press AUTO. You can also press
Digital Zoom -. When the key is pressed again, the picture is further reduced
until it is restored to the original size.
• Using the OSD menu
1. Press MENU/EXIT and then press
highlighted.
2. Press
displays.
3. Repeat steps 2-4 in the section of
are using the projector control panel, continue to the following steps.
4. Press
5. To navigate the picture, press MODE/ENTER to switch to the paning mode
and press the directional arrows ( ,
6. Use the directional arrows ( ,
to navigate the picture.
7. To reduce size of the picture, press MODE/ENTER to switch back to the zoom
in/out functionality, and press AUTO to restore the picture to its original size.
You can also press
The picture can only be navigated after the picture is magnified. You can further magnify the
picture while searching for details.

Selecting the aspect ratio

The 'aspect ratio' is the ratio of the image width to the image height. Most analog
TV and computers are in 4:3 ratio, which is the default for this projector, and digital
TV and DVDs are usually in 16:9 ratio.
With the advent of digital signal processing, digital display devices like this projector
can dynamically stretch and scale the image output to a different aspect than that of
the image input signal.
To change the projected image ratio (no matter what aspect the source is):
1. Press MENU/EXIT and then press
highlighted.
2. Press
to highlight Digital Zoom and press MODE/ENTER. The Zoom bar
on the projector repeatedly to magnify the picture to a desired size.
repeatedly until it is restored to the original size.
to highlight Aspect Ratio.
, , )
/ until the DISPLAY menu is
"Using the remote control"
, , ) to navigate the picture.
, , ) on the projector or remote control
/ until the DISPLAY menu is
above. Or if you
Operation 27