Step By Step Modification Of The Printer Setup - Datamax M-Class Mark II M-4206 Operator's Manual

4.5.3 Step by Step Modification of the Printer Setup

The following is an example of Printer Setup modification. Although this example will detail how to modify the serial
Baud Rate, the same method can be used to change any of the printer's menu item settings.
Note: It is recommended that the Printer Setup Mode not be entered while in Peel Mode or with the optional Present Sensor
enabled. Depending on label size this can cause unpredictable results.
1. With printer 'Off' and properly loaded with media, press and hold the
Continue to hold the button until the
2. Press and hold the
should be produced:
3. Press the button one time to increment to the 19200 bps value. The following printout should be produced:
PAUSE
4. At this point you will accept the current values for "test" and exit the Printer Setup Procedure by simultaneously and
briefly pressing the
Note: If you wish to discard your changes and revert back to the previous values simply turn off power to the printer before Step
5.
5. Now you can save your changes and resume
buttons. Wait until the
CANCEL
24
light turns off, then release it.
STOP
button and count 7 flashes of the
FEED
+ buttons. Wait until the
PAUSE CANCEL
light goes off.
STOP
button while powering 'On' the printer.
PAUSE
light, then release it. The following printout
ERROR
light goes off.
STOP
by simultaneously and briefly pressing the +
PAUSE
M-4206