Table of Contents
Advertisement
3.
Lay the computer on its side with the rear facing toward you.
4.
Remove the front bezel
5.
Remove an expansion cards
6.
Disconnect the power, and data cables from the back of all installed drives.
7.
Disconnect all cables from the system board.
8.
Remove the eight screws that secure the system board to the chassis.
NOTE:
System board appearance varies by model.
9.
Slide the system board toward the front of the chassis, and then lift it up and out of the chassis.
NOTE:
To install the system board, reverse the removal procedure.
NOTE:
When replacing the system board, you must also change the chassis serial number in the
BIOS.
NOTE:
After installing a new system board, always update the system ROM to ensure that the
latest version of the BIOS is being used on the computer. The latest system ROM BIOS can be found
at: http:\\h18000.www1.hp.com/support/files.
72
Chapter 6 Removal and Replacement Procedures Microtower (MT) Chassis
(Front Bezel on page
(Expansion Cards on page
HP Pro 3015 shown.
The system board in the computer may look slightly different from the one shown here.
34).
41).
Hide quick links:
Advertisement
Table of Contents
