Page 1
CD-ROM included with this product. NOTE DX8200A-3002 Figure A Laser Safety Label Mounting Reference Label Figure B TX Data LED (Green) Network LED (Red) LCD Display Figure C Lonworks 17-pin Male Connector Lonworks 17-pin Female Connector DX8200A-3002 QUICK GUIDE...
Supervisor (up to 5 arrays) Sentinel-10 Supervisor (up to 10 arrays) Sentinel-32 Supervisor (up to 32 arrays) DX8200A-3002 QUICK GUIDE 0° to +50 °C (+32° to +122 °F) -20° to +70 °C (-4° to +158 °F) 90% non condensing 20000 lux Frequency range from 5 to 150 Hz;...
Electrical Connections: Two 17-pin connectors provide access to the scanner’s local Lonworks network used for both input and output connections to build a multi-sided or omni-station system. Function Name Supply voltage (negative pin) Supply voltage 20 to 30 Vdc (positive pin)
Page 5
CAB-SC6003 CAB-SC6003 Extended I/O LONWORKS BTK8500 CAB-850x Bus Return CAB-850x up to 3 scanners branch DX8200A-3002 DX8200A-3002 CAB-850x up to 4 branch DS8100A-3002 DX8200A-3002 Typical Layout DX8200A-3002 QUICK GUIDE VAC INPUT ENCODER PS Aux BTK8500 Bus Return CAB-850x DS8100A-3002 DS8100A-3002...
Page 6
CAB-850x DX8200A Redundancy CAB-PWO 03 Power/Net CAB-SC6003 CAB-SC6003 Extended I/O LONWORKS CAB-850x CAB-850X CAB-850x DX8200A Example of Redundant System Layout DX8200A-3002 QUICK GUIDE VAC INPUT ENCODER PS Aux BTK8500 CAB-850x DS8100A DS8100A VAC INPUT ENCODER PS Aux BTK8500 CAB-850x DS8100A...
Page 7
DX8200A-3002 QUICK GUIDE Example of Redundant System...
Mechanical Installation: DX8200A-3002 can be installed to operate in any position. There are 4 slots (dia. 8.5 mm) on the sides of the scanner for mounting. The diagram below can be used for installation; refer to the Reading Diagrams for correct positioning of the scanner with respect to the reading zone and scanner orientation.
Reading Diagrams: Note: x = 0 and z = 0 correspond to the edge of the DX8200A-3002 scanner as shown in the figure below. CONDITIONS Code = Interleaved 2/5 or Code 39 PCS = 0.90 Compliance: Laser Safety Figure A...
Page 10
This product is intended to be installed by Qualified Personnel only. This scanner is intended to be supplied by either a UL Listed power supply marked 'Class 2' or 'LPS', output rated 20 - 30 V dc, minimum 1.75 A or by a UL Listed computer with LPS outputs.
Page 11
Gerät declare que el DX8200A-XXXX, Laser Scanner sono conformi alle Direttive del Consiglio Europeo sottoelencate: are in conformity with the requirements of the European Council Directives listed below: sont conformes aux spécifications des Directives de l'Union Européenne ci-dessous: den nachstehenden angeführten Direktiven des Europäischen Rats:...