Completing The Installation Of A Hard Disk Drive; Installing A Drive In A Front-Access Shelf - HP Kayak XA05 Supplementary Manual

When a New SCSI Hard
Disk Drive Is Installed
When an IDE Drive
Is Installed
NOTE

Completing the Installation of a Hard Disk Drive

1 Switch on the computer.
2 To ensure compatibility, use the FDISK utility to delete any
partitions on the new hard disk.
3 Re-boot the computer.
Refer to the operating system documentation for information on
formatting a drive.
1 Switch on the computer.
2 To display the device in POST, press
re-starts.
3 If an error message appears, follow the instructions provided by the
Error Message Utility.
4 To verify the configuration of your hard disk drive, press
Setup when prompted. Once in Setup, select the
the submenu. In the
IDE Devices
details for the device have been correctly detected by the Setup
program.
5 Press to save and exit Setup.
F3
Refer to the operating system documentation for information on
formatting a drive.
If you have removed an IDE drive, switch on the computer. The system
BIOS will detect that the device is missing. Press
want to remove the device. The system configuration will be updated
automatically.

Installing a Drive in a Front-Access Shelf

These instructions explain how to install a drive (such as a flexible disk
drive, a CD-ROM drive, CD-RW drive, or a tape drive) in one of the
front-access drive shelves. You should also refer to the manual supplied
with the drive for any additional installation instructions.
2 How to Install Accessories In Your Minitower PC Workstation
Esc
Primary Master
Installing Mass Storage Devices
while the PC Workstation
to enter
F2
menu, then
Advanced
item, check that the
to confirm that you
F4
English 43