Using Hp Maxilife To Diagnose Problems - HP Kayak XA-s02 User Manual

geron.bk : geron-3.fb4 Page 69 Friday, April 24, 1998 5:30 PM
Pre-Boot Checks
Note: Some error
messages displayed here
may not be available.

Using HP MaxiLife to Diagnose Problems

Your HP LCD can help you to diagnose problems with your PC
Workstation, even when you are unable to get your system and monitor
working properly.
When you press your PC Workstation's on/off button, HP MaxiLife will
check your system before it initiates the start-up sequence. You will see
one of the following screens on the LCD as these checks progress:
Error!
CPU Socket
Check that a CPU or terminator Check power supply and
is installed in the CPU slots. power cable connections.
Error!
Power CPU 2
Check processor 2 VRM
installation.
Error!
BIOS
Flash new BIOS or start Check that graphics card
system using crisis switch is installed correctly.
(system board switch 10).
Error!
RAM type
Check that RAM types
installed are compatible.
3 Troubleshooting Your HP Kayak PC Workstation
Using HP MaxiLife to Diagnose Problems
Error!
Power supply
Check processor 1 VRM
installation.
Error!
Power
Check that configuration of
VRMs and terminators is
correct or that the power
supply is properly connected.
Error!
No Video
Check memory installation.
HP KAYAK XA-s
No errors occurred during pre-
boot. POST is initiated.
Error!
Power CPU 1
Error!
Board PLL
Check system board.
Error!
No RAM
English 69