HP Kayak XA-s02 User Manual page 56

geron.bk : geron-2.fb4 Page 46 Friday, April 24, 1998 5:30 PM
NOTE
Ensure that the retaining
latches on either side of
the processor are out
before installation.
2 How to Install Accessories In Your HP Kayak PC Workstation
Installing a Processor
6 The system board has two processor sockets and a VRM slot for each
processor (refer to the illustrations below).
a If you are changing the existing processor, remove it from the
socket by squeezing the tabs at the top of the processor and
gently pulling the processor away from the system board. Then
remove the VRM for the processor.
b If you are installing a processor, remove the terminator from the
socket, if one is installed. Ensure that the retaining latches on
either side of the new processor are pushed out, and gently slide
it into the processor socket until it snaps into place (the
processor can go in one way only).
If one of the processor's retaining latches is inadvertently pushed in, you
will need to release it before installation.
46 English