Scsi Interface Error Messages; A.19 Scsi Interface Error Messages (65 Xx - Xx , 66 Xx - Xx , 67 Xx - Xx ); Pointing Device Interface Error Messages (8601- Xx - HP Compaq d330 DT Technical Reference Manual

A.19 SCSI INTERFACE ERROR MESSAGES (65xx-xx, 66xx-xx, 67xx-xx)
Table A–18. SCSI Interface Error Messages
Message Probable Cause
6nyy-02 Drive not installed
6nyy-03 Media not installed
6nyy-05 Seek failure
6nyy-06 Drive timed out
6nyy-07 Drive busy
6nyy-08 Drive already reserved
6nyy-09 Reserved
6nyy-10 Reserved
6nyy-11 Media soft error
6nyy-12 Drive not ready
6nyy-13 Media error
6nyy-14 Drive hardware error
6nyy-15 Illegal drive command
6nyy-16 Media was changed
6nyy-17 Tape write-protected
6nyy-18 No data detected
6nyy-21 Drive command aborted
6nyy-24 Media hard error
6nyy-25 Reserved
6nyy-30 Controller timed out
6nyy-31 Unrecoverable error
6nyy-32 Controller/drive not connected
n = 5, Hard drive
= 6, CD-ROM drive
= 7, Tape drive.
A.20 POINTING DEVICE INTERFACE ERROR MESSAGES (8601-xx)
Table A–19. Pointing Device Interface Error Messages
Message Probable Cause
8601-01 Mouse ID fails
8601-02 Left mouse button is inoperative
8601-03 Left mouse button is stuck closed
8601-04 Right mouse button is inoperative
8601-05 Right mouse button is stuck closed
8601-06 Left block not selected
Table A-18.

SCSI Interface Error Messages

Message
6nyy-33
6nyy-34
6nyy-35
6nyy-36
6nyy-39
6nyy-40
6nyy-41
6nyy-42
6nyy-43
6nyy-44
6nyy-50
6nyy-51
6nyy-52
6nyy-53
6nyy-54
6nyy-60
6nyy-61
6nyy-65
6nyy-90
6nyy-91
6nyy-92
6nyy-99
yy = 00, ID
= 03, Power check
= 05, Read
= 06, SA/Media
= 08, Controller
= 23, Random read
= 28, Media load/unload
Table A-19.
Pointing Device Interface Error Messages
Message
8601-07
8601-08
8601-09
8601-10
8602-xx
--
Changed – April 2003
Technical Reference Guide
Probable Cause
Illegal controller command
Invalid SCSI bus phase
Invalid SCSI bus phase
Invalid SCSI bus phase
Error status from drive
Drive timed out
SSI bus stayed busy
ACK/REQ lines bad
ACK did not deassert
Parity error
Data pins bad
Data line 7 bad
MSG, C/D, or I/O lines bad
BSY never went busy
BSY stayed busy
Controller CONFIG-1 register fault
Controller CONFIG-2 register fault
Media not unloaded
Fan failure
Over temperature condition
Side panel not installed
Autoloader reported tape not loaded properly
Probable Cause
Right block not selected
Timeout occurred
Mouse loopback test failed
Pointing device is inoperative
I/F test failed
--
hp/Compaq Personal Computers A-11