Memory Detection And Configuration; Boot Error Codes - HP Compaq d330 DT Technical Reference Manual

8.3.3 MEMORY DETECTION AND CONFIGURATION

This system uses the Serial Presence Detect (SPD) method of determining the installed DIMM
configuration. The BIOS communicates with an EEPROM on each DIMM through the SMBus to
obtain data on the following DIMM parameters:
♦ Presence
♦ Size
♦ Type
♦ Timing/CAS latency
♦ PC133 capability
NOTE: Refer to Chapter 3, "Processor/Memory Subsystem" for the SPD format and
DIMM data specific to this system.
The BIOS performs memory detection and configuration with the following steps:
1. Program the buffer strength control registers based on SPD data and the DIMM slots that are
populated.
2. Determine the common CAS latency that can be supported by the DIMMs.
3. Determine the memory size for each DIMM and program the GMCH accordingly.
4. Enable refresh
5. Determine if the memory configuration will allow for 133MHz memory operation and
program the memory clock and MCH (see note below)
NOTE: The presence of PC133-compliant DIMMS will be indicated by BIOS reading
75h from byte 9 and 64h or 85h from byte 126. For PC133 operation to occur the FSB of
the processor must be running at 133 MHz and all installed DIMMs must be
PC133-compliant and total no more than four "sides." Refer to Chapter 3 for more details
on PC133 operation.

8.3.4 BOOT ERROR CODES

The BIOS provides visual and audible indications of a failed system boot by using the keyboard
LEDs and the system speaker. The error conditions are listed in the following table.
Table 8-2. Boot Error Codes
Visual [1]
Num Lock LED blinks
Scroll Lock LED blinks
Caps Lock LED blinks
Num, Caps, Scroll Lock LEDs
blink
Num, Caps, Scroll Lock LEDs
blink in sequence
NOTE:
[1] Provided with PS/2 keyboard only.
Table 8-2. Boot Error Codes
Audible Meaning
1 short, 2 long beeps System memory not present or incompatible.
2 long, 1 short beeps Hardware failure before graphics initialization.
1 long, 2 short beeps Graphics controller not present or failed to
initialize.
1 long, 3 short beeps ROM failure.
none Network service mode
hp compaq d330 and d530 Series of Personal Computers
Featuring the Intel Pentium 4 Processor
First Edition - June 2003
Technical Reference Guide
8-5