To Run The Diagnostic Test - HP OmniBook 7100 Reference Manual

Troubleshooting

To run the diagnostic test

1. Insert the diagnostic disk in the floppy drive.
2. Reboot the OmniBook.
3. Go through the first several screens.
4. When the hardware detection finishes, check the list of detected hardware.
If a device is not detected or fails its test below, it may be configured incorrectly in
the BIOS Setup utility. You can confirm the problem by running BIOS Setup and
checking the settings.
5.
6. If you intend to exit without running advanced tests, press F4 to save system and
test information in the Support Ticket log file, HPSUPPT.TXT. Then remove the
diagnostic disk and press F3 to exit.
7.
8. Select and run the appropriate tests. Tests are not listed if no such hardware is
detected. Press the following keys to run tests:
ENTER Runs the highlighted test.
F5 or SPACE Marks or unmarks the highlighted test.
F6 Marks or unmarks all tests in the current menu.
F7 Marks or unmarks all tests in all menus.
F10 Runs all marked tests.
9. When you are finished running tests, press ESC to exit the advanced tests.
10. Optional: Press F4 to save system and test information in the Support Ticket log
file, HPSUPPT.TXT.
11. . Press F3 to exit and reboot.
7-16
. Press F2 to start the basic hardware test.
. Press F2 to open the advanced test screen.