To Activate Full Pointing Stick Capabilities - HP OmniBook 7100 Reference Manual

Operating the OmniBook

To activate full pointing stick capabilities

If you have activated full touch pad capabilities, you can use this procedure to
switch back to full pointing stick capabilities. You'll need to do the following:
Remove the touch pad driver (Windows 95 only).
Enable the pointing stick.
Install pointing stick support.
1. Remove the touch pad driver (Windows 95 only)
From Control Panel, click Add/Remove Program and remove touch pad
support.
2. Enable the pointing stick
1. From the Start menu, shut down, then restart the OmniBook.
2. When you see the HP logo, press F2 to enter the BIOS Setup utility.
3. Select the System Devices menu.
4. Highlight Internal Pointing Devices and select Pointing Stick. (Choose Both if
you want basic touch pad features available.)
5. Press F10 to save and exit.
3. Install pointing stick support
From Control Panel, open Mouse, General and change the mouse type--click
Have Disk and point to the directory listed below and select PS/2 TrackPoint.
c:\omnibook\drivers\win95\trackpnt.
c:\omnibook\drivers\nt40\trackpnt.
2-8