Display Assembly - HP 510 Maintenance And Service Manual

Display assembly

Description
15.4-inch, WXGA BrightView display assembly for use only with computer models
with wireless LAN capability (includes wireless antenna transceivers and cables)
15.4-inch, WXGA BrightView display assembly for use only with computer models
without wireless LAN capability
Before removing the display assembly, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power cord.
4. Remove the battery (see
5. Remove the memory/Mini PCI card module compartment cover (see
on page
PCI card module on page
6. Remove the following components:
a. Switch cover (see
b. Keyboard (see
Remove the display assembly:
1. Close the computer and turn it upside down with the rear panel toward you.
2. Remove the two Phillips PM2.0×7.0 screws that secure the display assembly to the computer.
3. Turn the computer display-side up, with the front toward you.
4. Open the computer until the display assembly is in an upright position.
44 Chapter 5 Removal and replacement procedures
Battery on page
32) and disconnect the wireless antenna cables from the Mini PCI card module (see
34).
Switch cover on page
Keyboard on page
29).
38)
40)
Spare part number
440716-001
440715-001
Memory module
Mini
ENWW