Hard Drive - HP 510 Maintenance And Service Manual

Hard drive

Description
5400-rpm, 60-GB
4200-rpm, 40-GB
Before disassembling the computer, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power cord.
4. Remove the battery (see
Remove the hard drive:
1. Position the computer with the front toward you.
2. Loosen the two Phillips PM2.5×6.0 screws (1) that secure the hard drive cover to the computer.
3. Lift the left side of the hard drive cover (2) and swing it to right.
4. Remove the hard drive cover.
NOTE
441630-001.
5. Grasp the Mylar tab (1) on the hard drive and pull the hard drive (2) to the left to disconnect it from
the system board.
30 Chapter 5 Removal and replacement procedures
Battery on page
The hard drive cover is included in the Plastics/Hardware Kit, spare part number
Spare part number
438526-001
438525-001
29).
ENWW