Fan Assembly - HP 510 Maintenance And Service Manual

Fan assembly

Description
Fan assembly
Before removing the fan assembly, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power cord.
4. Remove the battery (see
5. Remove the following components:
a. Hard drive (see
b. Memory/Mini PCI card module compartment cover (see
c. Optical drive (see
d. Switch cover (see
e. Keyboard (see
f. Display assembly (see
g. Base enclosure (see
Remove the fan assembly:
1. Disconnect the fan cable (1) from the system board.
2. Remove the Phillips PM2.0×9.0 screw (2) that secures the fan assembly to the top cover.
3. Remove the fan assembly (3).
52 Chapter 5 Removal and replacement procedures
Battery on page 29).
Hard drive on page 30)
Optical drive on page
Switch cover on page
Keyboard on page 40)
Display assembly on page
Base enclosure on page
Spare part number
438528-001
Memory module on page
36)
38)
44))
49)
32)
ENWW