Table of Contents
Advertisement
To lubricate the headstock slide shafts and
leadscrew:
1.
DISCONNECT THE BORING MACHINE
FROM POWER!
2.
Set the depth control to "0".
3.
Clean sawdust and debris from the visibile
sections of the headstock slide shafts and
leadscrew (see Figures 32–33).
Headstock
Slide Shafts
(1 of 2)
Figure 32. Headstock slide shafts (1 of 2
shown).
Leadscrew
Figure 33. Headstock leadscrew.
-24-
NOTICE
Failure to perform proper lubrication main-
tenance on this machine will lead to prema-
ture wear of the moving parts, and will void
the warranty.
4.
Apply a thin coat of light machine oil to the
slide shafts and leadscrew.
5.
With the power still disconnected, set the
depth control to 0.50" and use the foot pedal
to move the boring head up and down a few
times to evenly distribute the lubricant along
the slide shafts and leadscrew.
Model G0643 21-Bit Line Boring Machine
Advertisement
Table of Contents
