Assembly - Grizzly G0643 Owner's Manual

Assembly

Serious personal injury could occur if you
connect the machine to power before com-
pleting the setup process. DO NOT connect
the machine to the power until instructed
later in this manual.
After mounting the boring machine to your shop
floor and providing the correct electrical connec-
tion, assemble the additional components.
To assemble your machine:
1.
Slide the longitudinal fence assembly under
the headstock as shown in Figure 10.
Locking Assembly
Figure 10. Longitudinal fence positioned for
mounting to machine.
Note: Make sure the locking assembly of the
longitudinal fence is facing the rear of the
machine, as shown in Figure 10.
-14-
Fence Assembly
2.
Thread the locking lever of the longitudinal
fence into the hex nut that is located in the
cross fence slot (see Figure 11).
Hex Nut
Figure 11. Longitudinal and cross fence
attachment components.
3.
Move the longitudinal fence up against the
headstock column, and tighten both locking
levers to hold it in place.
4.
Position the table over the mounting flang-
es of the longitudinal fence, as shown in
Figure 12.
Mounting
Flange
Figure 12. Table mounted to longitudinal fence.
5.
Secure the table to the longitudinal fence with
the four M6-1 x 35 flat head cap screws, flat
washers, and hex nuts.
Model G0643 21-Bit Line Boring Machine
Locking
Lever
Locking
Block
Cap Screws