Table of Contents
Advertisement
USB-ZIP
USB-CDROM
USB-HDD
LAN
Disabled
Boot Up Floppy Seek
During POST, BIOS will determine the floppy disk drive installed is 40 or 80 tracks. 360K type is
40 tracks 720K, 1.2M and 1.44M are all 80 tracks.
Enabled
Disabled
Password Check
8Setup
8System
Flexible AGP 8X
Auto
8X
4X
Init Display First
This feature allows you to select the first initiation of the monitor display from which card when you
install an AGP card and a PCI VGA card on board.
PCI slot
Onboard/AGP Set initial display first to AGP.
GA-K8N Pro Motherboard
K8n pro_1001_b.p65
Select your boot device priority by USB-ZIP.
Select your boot device priority by USB-CDROM.
Select your boot device priority by USB-HDD.
Select your boot device priority by LAN.
Select your boot device priority by Disabled.
BIOS searches for floppy disk drive to determine it is 40 or 80 tracks. Note
that BIOS can not tell from 720K, 1.2M or 1.44M drive type as they are all
80tracks.
BIOS will not search for the type of floppy disk drive by track number. Note
that there will not be any warning message if the drive installed is 360K.
(Default value)
The system will boot but will not access to Setup page if the correct
password is not entered at the prompt. (Default value)
The system will not boot and will not access to Setup page if the correct
password is not entered at the prompt.
Automatically set AGP transfer rate according to AGP compatibility and
stability. (Default value)
Always set AGP transfer rate to 8X mode if the 8X mode supported by the AGP
card.
Set AGP transfer rate to 4X mode no matter what the AGP transfer rate the
card is.
Set initial display first to PCI slot. (Default value)
- 46 -
46
2003/8/18, ¤U¤È 06:08
Advertisement
Table of Contents
