Integrated Peripherals - Gigabyte GA-946GZ-DS3 User Manual

Onboard VGA
This item allows the user to decide when to activate the onboard VGA function.
Enable If No Ext PEG Activate the onboard VGA first only when no PCI Express VGA card is
installed. (Default value)
Always Enable
Always activate the onboard VGA first, whether or not a PCI Express card is installed. If you wish
to set up a dual view configuration, set this item to Always Enable.
On-Chip Frame Buffer Size
1MB Set on-chip frame buffer size to 1MB.
8MB Set on-chip frame buffer size to 8MB. (Default value)
2-3

Integrated Peripherals

CMOS Setup Utility-Copyright (C) 1984-2006 Award Software
On-Chip Primary PCI IDE
On-Chip SATA Mode
x PATA IDE Set to
SATA Port 0/2 Set to
SATA Port 1/3 Set to
USB Controller
USB 2.0 Controller
USB Keyboard Support
USB Mouse Support
Legacy USB storage detect
Azalia Codec
Onboard H/W LAN
SMART LAN
OnBoard LAN Boot ROM
Onboard Serial Port 1
Onboard Parallel Port
Parallel Port Mode
: Move Enter: Select
F5: Previous Values
On-Chip Primary PCI IDE
Enabled
Disabled
On-Chip SATA Mode
Disabled
Auto
Combined
Enhanced
Non-Combined
GA-946GZ-DS3 (rev. 2.0) Motherboard
Integrated Peripherals
[Enabled]
[Auto]
Ch.0 Master/Slave
Ch.2 Master/Slave
Ch.3 Master/Slave
[Enabled]
[Enabled]
[Disabled]
[Disabled]
[Enabled]
[Auto]
[Enabled]
[Press Enter]
[Disabled]
[3F8/IRQ4]
[378/IRQ7]
[SPP]
+/-/PU/PD: Value F10: Save
F6: Fail-Safe Defaults
Enable onboard 1st channel IDE port. (Default value)
Disable onboard 1st channel IDE port.
Disable this function.
BIOS will auto detect. (Default value)
Set On-Chip SATA mode to Combined, you can use up to 4 HDDs on
the motherboard; 2 for SATA and the other for PATA.
Set On-Chip SATA mode to Enhanced, the motherboard allows up to 6
HDDs to use; 4 SATA HDDs plus PATA HDDs.
Set On-Chip SATA mode to Non-Combined, SATA will be simulated to
PATA mode. Support a maximum of 4 SATA devices. PATA devices will be
ignored.
- 36 -
Item Help
Menu Level
ESC: Exit F1: General Help
F7: Optimized Defaults