Integrated Peripherals - Gigabyte GA-945GCM-S2 User Manual

2-3

Integrated Peripherals

CMOS Setup Utility-Copyright (C) 1984-2007 Award Software
On-Chip Primary PCI IDE
On-Chip SATA Mode
x PATA IDE Set to
SATA Port 0/2 Set to
SATA Port 1/3 Set to
USB Controller
USB 2.0 Controller
USB Keyboard Support
USB Mouse Support
Legacy USB storage detect
Azalia Codec
Onboard H/W LAN
SMART LAN
Onboard LAN Boot ROM
Onboard Serial Port 1
Onboard Serial Port 2
Onboard Parallel Port
Parallel Port Mode
x ECP Mode Use DMA
: Move Enter: Select
F5: Previous Values
On-Chip Primary PCI IDE
Enabled
Disabled
On-Chip SATA Mode
Disabled
Auto
Combined
Enhanced
Non-Combined
PATA IDE Set to
Ch.0 Master/Slave Set PATA IDE to Ch. 0 Master/Slave. (Default value)
Ch.1 Master/Slave Set PATA IDE to Ch. 1 Master/Slave.
SATA Port 0/2 Set to
This value will auto make by the setting "On-Chip SATA Mode" and "PATA IDE Set to".
If PATA IDE were set to Ch. 1 Master/Slave, this function will auto set to Ch. 0 Master/Slave.
SATA Port 1/3 Set to
This value will auto make by the setting "On-Chip SATA Mode" and "PATA IDE Set to".
If PATA IDE were set to Ch. 0 Master/Slave, this function will auto set to Ch. 1 Master/Slave.
USB Controller
Enabled
Disabled
GA-945GCM(X)-S2 Motherboard
Integrated Peripherals
[Enabled]
[Auto]
Ch.0 Master/Slave
Ch.2 Master/Slave
Ch.3 Master/Slave
[Enabled]
[Enabled]
[Disabled]
[Disabled]
[Enabled]
[Auto]
[Enabled]
[Press Enter]
[Disabled]
[3F8/IRQ4]
[2F8/IRQ3]
[378/IRQ7]
[SPP]
3
+/-/PU/PD: Value
F6: Fail-Safe Defaults
Enable onboard 1st channel IDE port. (Default value)
Disable onboard 1st channel IDE port.
Disable this function.
BIOS will auto detect. (Default value)
Set On-Chip SATA mode to Combined, you can use up to 4 HDDs on
the motherboard; 2 for SATA and the other for PATA.
Set On-Chip SATA mode to Enhanced, the motherboard allows up to 6 HDDs
to use; 4 for SATA and the other for PATA.
Set On-Chip SATA mode to Non-Combined, SATA will be simulated to
PATA mode. Support a maximum of 4 SATA devices. PATA devices will be
ignored.
Enable USB controller. (Default value)
Disable USB controller.
- 38 -
Menu Level
F10: Save ESC: Exit
F7: Optimized Defaults
Item Help
F1: General Help