TP-Link SafeStream TL-R600VPN User Manual page 41

TL-R600VPN
Firewall - Enable the general firewall or not.
•
SPI Firewall - SPI (Stateful Packet Inspection) keeps track of the state of network
connections traveling across it. It distinguishes legitimate packets for different types of
connections. Only packets matching a known active connection will be allowed by the
firewall; others will be rejected. SPI Firewall is enabled by factory default. If you want all
the computers on the LAN exposed to the external network, you can disable it.
VPN - VPN Passthrough must be enabled if you want to allow VPN tunnels using VPN
protocols to pass through the Router.
•
PPTP Passthrough - Check the box before Enable to allow the PPTP tunnels to pass
through the router.
•
L2TP Passthrough - Check the box before Enable to allow the L2TP tunnels to pass
through the router.
•
IPSec Passthrough - Check the box before Enable to allow the IPSec tunnels to pass
through the router.
ALG - You can determine whether to provide ALG (Application Level Gateway) service for
FTP, TFTP, H323 and RTSP to keep these special applications from the effect of NAT
service.
•
FTP ALG - Select Enable to allow FTP services to operate properly.
•
TFTP ALG - Select Enable to allow TFTP services to operate properly.
•
H323 ALG - Select Enable to allow H323 services to operate properly.
•
RTSP ALG - Select Enable to allow RTSP services to operate properly.
TM
SafeStream Gigabit Broadband VPN Router User Guide
Figure 4-25
35