Table of Contents
Advertisement
Preparing your computer for RAID
Setting up RAID on your computer can involve two major steps,
depending on how your computer has been configured.
To prepare your computer for RAID:
1
2
Configuring RAID
Creating a RAID volume
Because RAID can be configured so many ways, this procedure
covers only the basics. This procedure assumes that no RAID
has been defined yet.
To create a RAID volume:
1
2
3
4
5
6
40
CHAPTER 4: Advanced Hardware Setup
Configure the RAID arrays. See the Array Manager User
Guide or
"Configuring RAID" on page
Install the operating system from the Windows disc that
came with your computer.
Install additional hard drives as needed for your RAID
plan. For instructions on installing hard drives, see
"Adding or replacing a hard drive" on page
Start (or restart) your computer, then press F9 during
startup. The MediaShield Utility (RAID setup) screen
opens.
To create a new array, set RAID Mode to Striping (for
RAID 0), then select drives on the left and click Add to
add the drives to the array.
Press F7, then press Y. The new array is created.
Press C
+
to exit the utility. Your computer restarts.
TRL
X
Install the operating system from the Windows disc that
came with your computer.
40.
52.
Advertisement
Table of Contents
