HP J4813A User Manual page 48

Getting Started
Using IDM Reports
2-28
4. Set the Start Date for enforcement of the policy. The default is the start
date and time for IDM.
You can type in a new date and time, or use the arrows to increase or
decrease the date and time entries. Note that the time clock uses 24 hour
format; thus a time of 22:00 is used to indicate a start time of 10:00 pm.
Check (click) the Run ASAP checkbox to reset the session statistics
immediately.
You can change the session cleanup interval using the Recurrence pattern
5.
options:
Table 9-1. IDM Session Cleanup Recurrence Pattern Options
If you select... The action is...
Never No further action is required (Policy definition is saved, but will not
be enforced).
One time No further action is required (the currently scheduled time is used
with no recurrences).
Hourly Type the number of hours and minutes to wait between session
cleanup. If you do not want the policy enforced on Saturdays and
Sundays, check the Skip weekend checkbox.
Daily Type the number of days to wait between session cleanups. If you
do not want the policy enforced on Saturdays and Sundays, check
the Skip weekend checkbox.
Weekly Check the boxes for the days of the week you want to enforce the
policy.
Monthly Click the Last day of the month button to enforce the schedule on
the last day of the month.
OR
Click the Day button and use the up or down arrows to select the
day of the month.
6. Click the radio button to select No end date, End by, or Maximum occurrences to
identify when the schedule should end.
If you select No end date, the schedule will run at the selected intervals
•
until the policy is changed or deleted.
If you selected End by, click the up and down arrows in the End by field
•
until the desired end date and time are shown.
• If you selected Maximum occurrences, type the number of times the policy
should be enforced before it is disabled automatically.
Click Finish to complete the process and exit the wizard.
7.