First Time Connecting To The Switch; Password Protection - D-Link xStack DES-3528P Hardware Installation Manual

®
xStack DES-3528/DES-3552 Series Layer 2 Stackable Fast Ethernet Managed Switch User Manual

First Time Connecting to the Switch

The Switch supports user-based security that can allow you to prevent unauthorized users from accessing the Switch
or changing its settings. This section tells how to log onto the Switch.
NOTE: The passwords used to access the Switch are case-sensitive; therefore, "S" is
not the same as "s."
When you first connect to the Switch, you will be presented with the first login screen.
NOTE: Press Ctrl+R to refresh the screen. This command can be used at any time to
force the console program in the Switch to refresh the console screen.
Press Enter in both the Username and Password fields. You will be given access to the command prompt DES-
3528:5# shown below:
There is no initial username or password. Leave the Username and Password fields blank.
Copyright(C) 2009 D-Link Corporation. All rights reserved.
Username:
PassWord:
DES-3528:5#
NOTE: The first user automatically gets Administrator level privileges. It is recommended to
create at least one Admin-level user account for the Switch.

Password Protection

The Switch does not have a default user name and password. One of the first tasks when settings up the Switch is to
create user accounts. Once logged in using a predefined administrator-level user name, users will have privileged
access to the Switch's management software.
After your initial login, define new passwords for both default user names to prevent unauthorized access to the
Switch, and record the passwords for future reference.
To create an administrator-level account for the Switch, follow these steps:
At the CLI login prompt, enter create account admin followed by the <user name> and press the Enter key.
The Switch will then prompt the user for a password. Type the <password> used for the administrator account being
created and press the Enter key.
Again, the user will be prompted to enter the same password again to verify it. Type the same password and press the
Enter key.
Successful creation of the new administrator account will be verified by a Success message.
DES-3528 Fast Ethernet Switch
Command Line Interface
Firmware: Build 2.00.B036
Figure 4- 2. Command Prompt
20