Cisco ME-C6524GS-8S Installation Manual page 68

Upgrading the Memory
Figure 4-6
Holding the old DRAM DIMM by its edges, gently rock and lift the DIMM to disconnect it from the
Step 7
DIMM socket. (See
it in an antistatic bag.
Figure 4-7
Carefully remove the new DRAM DIMM from its shipping packaging.
Step 8
Holding the new DRAM DIMM between your thumbs and forefingers, with the connector edge (the
Step 9
metal fingers) down, carefully slide the DIMM into the DIMM socket. Make sure that you fully insert
the connector edge of the DIMM into the socket connector.
Note
Cisco ME 6500 Series Ethernet Switch Installation Guide
4-12
Releasing the DIMM Socket Spring Clips
Memory module
Figure 4-7.) Immediately place the old DRAM DIMM on an antistatic mat or place
Handling the DRAM DIMM
A notch (key) is located on the left connector edge of the DIMM. This notch key ensures that
the DIMM is correctly oriented in the socket.
Chapter 4
Pull the tabs away with
your thumbs, bracing your
forefingers against the
rails. The memory module
will be released. Then raise
the memory module to
a vertical position.
Removal and Replacement Procedures
OL-8900-03