Cisco ME-C6524GS-8S Installation Manual page 53

Chapter 3 Installing the Switch
To insert an SFP transceiver into the SFP socket, follow these steps:
Attach an ESD grounding strap to your wrist and to ground. (If you are unsure about the correct way to
Step 1
attach an ESD grounding strap, see the
page 2-7
Remove the SFP transceiver from its protective packaging.
Step 2
Check the label on the SFP transceiver body to verify that you have the correct model for your network,
Step 3
and locate the send (Tx) and receive (Rx) markings that identify the top side of the SFP transceiver.
Note
Step 4 Carefully insert the SFP transceiver halfway into the socket. (See
dust plugs, pivot the transceiver bail-clasp up, and continue sliding the transceiver into the socket until
you feel the SFP transceiver module connector snap into place in the socket connector.
Pivot the SFP transceiver bail-clasp fully down to lock the transceiver in place, and immediately reinstall
Step 5
the dust plugs.
Figure 3-7 Installing an SFP Transceiver into an SFP Transceiver Socket
OL-8900-03
for instructions.)
On some SFP transceivers, the Tx and Rx marking might be replaced by arrows that point from
the SFP transceiver connector (transmit direction or Tx) to the connector (receive direction or
Rx).
"Preventing Electrostatic Discharge Damage" section on
Cisco ME 6500 Series Ethernet Switch Installation Guide
Installing the SFP Transceivers
Figure 3-7.) Remove the optical bore
3-13