Configure The Root Radio Station - Cisco CISCO851-K9 - 851 Integrated Services Router Configuration Manual

Configure the Root Radio Station

Configuration Tasks
Perform the following tasks to configure this network scenario:
•
•
•
A configuration example showing the results of these configuration tasks is provided in the
"Configuration Example" section on page
The procedures in this chapter assume that you have already configured basic router features as well as
Note
PPPoE or PPPoA with NAT. If you have not performed these configurations tasks, see
Router Configuration," Chapter 3, "Configuring PPP over Ethernet with NAT,"
"Configuring PPP over ATM with NAT,"
DHCP, VLANs, and secure tunnels.
Configure the Root Radio Station
Perform these steps to create and configure the root radio station for your wireless LAN, beginning in
global configuration mode:
Command
Step 1
interface name number
Example:
Router(config)# interface dot11radio 0
Router(config-if)#
Step 2 broadcast-key [vlan vlan-id] change seconds
Example:
Router(config-if)# broadcast-key vlan 1
change 45
Router(config-if)#
Cisco 850 Series and Cisco 870 Series Access Routers Software Configuration Guide
9-2
Configure the Root Radio Station
Configure Bridging on VLANs
Configure Radio Station Subinterfaces
Chapter 9
9-7.
as appropriate for your router. You may have also configured
Purpose
Enters interface configuration mode for the
radio interface.
Specifies the time interval, in seconds, between
rotations of the broadcast encryption key used
for clients.
Note Client devices using static Wired
Equivalent Privacy (WEP) cannot use
the access point when you enable
broadcast key rotation—only wireless
client devices using 802.1x
authentication (such as Light Extensible
Authentication Protocol [LEAP],
Extensible Authentication
Protocol–Transport Layer Security
[EAP-TLS], or Protected Extensible
Authentication Protocol [PEAP]) can
use the access point.
This command is not supported on
Note
bridges.
See the Cisco IOS Commands for Access Points
and Bridges for more details.
Configuring a Wireless LAN Connection
Chapter 1, "Basic
and Chapter 4,
OL-5332-01