Configure Bridging On Vlans - Cisco CISCO851-K9 - 851 Integrated Services Router Configuration Manual

Configure Bridging on VLANs

Command
Step 10
power [client | local] [cck [number | maximum] |
ofdm [number | maximum]]
Example:
Router(config-if)# power local cck 50
Router(config-if)# power local ofdm 30
Router(config-if)#
Step 11 channel [number | least-congested]
Example:
Router(config-if)# channel 2462
Router(config-if)#
Step 12 station-role [repeater | root]
Example:
Router(config-if)# station-role root
Router(config-if)#
Step 13
exit
Example:
Router(config-if)# exit
Router(config)#
Configure Bridging on VLANs
Perform these steps to configure integrated routing and bridging on VLANs, beginning in global
configuration mode:
Command or Action
Step 1 bridge [number | crb | irb |mac-address-table]
Example:
Router(config)# bridge irb
Router(config)#
Step 2 interface name number
Example:
Router(config)# interface vlan 1
Router(config)#
Cisco 850 Series and Cisco 870 Series Access Routers Software Configuration Guide
9-4
Chapter 9 Configuring a Wireless LAN Connection
Purpose
(Optional) Specifies the radio transmitter power
level.
See the Cisco Access Router Wireless
Configuration Guide for available power level
values.
(Optional) Specifies the channel on which
communication occurs.
See the Cisco Access Router Wireless
Configuration Guide for available channel
numbers.
(Optional) Specifies the role of this radio
interface.
You must specify at least one root interface.
Exits interface configuration mode, and enters
global configuration mode.
Purpose
Specifies the type of bridging.
The example specifies integrated routing and
bridging.
Enters interface configuration mode.
We want to set up bridging on the VLANs, so the
example enters the VLAN interface
configuration mode.
OL-5332-01