Configuration Example - Cisco CISCO851-K9 - 851 Integrated Services Router Configuration Manual

Chapter 4 Configuring PPP over ATM with NAT
Command
Step 10
exit
Example:
Router(config-if)# exit
Router(config)#
Step 11
access-list access-list-number {deny | permit}
source [source-wildcard]
Example:
Router(config)# access-list 1 permit
192.168.1.0 255.255.255.0
If you want to use NAT with a virtual-template interface, you must configure a loopback interface. See
Note
Chapter 1, "Basic Router Configuration,"
For complete information on NAT commands, see the Cisco IOS Release 12.3 documentation set. For
more general information on NAT concepts, see

Configuration Example

The following configuration example shows a portion of the configuration file for a client in the PPPoA
scenario described in this chapter.
The VLAN interface has an IP address of 192.168.1.1 with a subnet mask of 255.255.255.0. NAT is
configured for inside and outside.
Commands marked by "(default)" are generated automatically when you run the show running-config
Note
command.
!
interface Vlan1
ip address 192.168.1.1 255.255.255.0
ip nat inside
ip virtual-reassembly (default)
!
interface ATM0
no ip address
ip nat outside
ip virtual-reassembly
no atm ilmi-keepalive
pvc 8/35
encapsulation aal5mux ppp dialer
dialer pool-member 1
!
dsl operating-mode auto
!
OL-5332-01
for information on configuring the loopback interface.
Appendix B, "Concepts."
Cisco 850 Series and Cisco 870 Series Access Routers Software Configuration Guide
Purpose
Exits configuration mode for the ATM interface.
Defines a standard access list permitting addresses
that need translation.
Note All other addresses are implicitly denied.
Configuration Example
4-11