Chapter 13
Configuring Dial Backup and Remote Management
Command
Step 3
exit
Example:
Router(config-dhcp)# exit
Router(config)#
Step 4
chat-script script-name expect-send
Example:
Router(config)# chat-script Dialout ABORT
ERROR ABORT BUSY "" "AT" OK "ATDT 5555102
T" TIMEOUT 45 CONNECT \c
Router(config)#
Step 5
interface type number
Example:
Router(config)# interface Async 1
Router(config-if)#
Step 6
exit
Example:
Router(config-if)# exit
Router(config)#
Step 7
interface type number
Example:
Router(config)# interface Dialer 3
Router(config-if)#
Step 8
dialer watch-group group-number
Example:
Router(config-if)# dialer watch-group 1
Router(config-if)#
Step 9
exit
Example:
Router(config-if)# exit
Router(config)#
OL-5332-01
Configuring Dial Backup and Remote Management Through the Console or Auxiliary Port
Cisco 850 Series and Cisco 870 Series Access Routers Software Configuration Guide
Purpose
Enters global configuration mode.
Configures a chat script used in dial-on-demand
routing (DDR) to give commands to dial a modem
and to log in to remote systems. The defined script
is used to place a call over a modem.
Creates and enters configuration mode for the
asynchronous interface.
Configure the asynchronous interface. For
•
sample commands you can use in async
interface configuration mode, see the
"Configuration Example" section on
page
13-13.
Enters global configuration mode.
Enters interface configuration mode.
Specifies the group number for watch list.
Enters global configuration mode.
13-11