Casio FX-7400GII - SOFTWARE VERSION 2-00 User Manual page 319

Data Item
RECURSION*
SETUP
STAT
<STRING>
n
STR
SYSTEM
<S-SHEET>
Spreadsheet data
names
TABLE
<V-WIN>
n
V-WIN
Y=DATA
1
* No overwrite check: If the receiving unit already contains the same type of data, the existing
data is overwritten with the new data.
With overwrite check: If the receiving unit already contains the same type of data, a
message appears to ask if the existing data should be overwritten with the new data.
• (YES) ... {replaces the receiving unit's existing data
with the new data}
• (NO) ... {skips to next data item}
Note the following precautions whenever you perform data communications.
• An error occurs whenever you try to send data to a receiving unit that is not yet standing by
to receive data. When this happens, press
up the receiving unit to receive data.
• An error occurs whenever the receiving unit does not receive any data approximately six
minutes after it is set up to receive data. When this happens, press
• An error occurs during data communications if the cable becomes disconnected, if the
parameters of the two units do not match, or if any other communications problem occurs.
When this happens, press
communications again. If data communications are interrupted by the
an error, any data successfully received up to the interruption will be in the memory of the
receiving unit.
• An error occurs if the receiving unit memory becomes full during data communications. When
this happens, press
to make room for the new data, and then try again.
Contents
Recursion data
Setup data
Stat result data
String memory group
String memory (1 to 20) data
OS and data shared by applications (clipboard,
replay, history, etc.)
Spreadsheet group
Spreadsheet data
(All spreadsheet data are listed.)
Table data
V-Window memory group
V-Window memory (1 to 6) contents
Graph expressions, graph draw/non-draw status,
V-Window contents, zoom factors
Data item name
to clear the error, then correct the problem before trying data
to clear the error and delete unneeded data from the receiving unit
13-6
to clear the error and try again, after setting
1
Overwrite Check*
No
No
No
No
No
Yes
No
No
No
to clear the error.
key operation or