Eizo FlexScan S1932 User Manual page 13

3
Perform the AutoSize adjustment again with the analog screen
adjustment pattern displayed.
● To adjust flickering, screen position, and screen size
automatically [AutoSize]
(1) Display Pattern 1 in full screen on the monitor using the "Screen
Adjustment Utility" or the screen adjustment pattern files.
(2) Press .
The adjustment menu appears.
(3) Select (Analog).
(4) Select (AutoSize).
Flickering, screen position, and screen size are adjusted automatically.
(5) After confirming the screen message, select
If you select
If the screen is not displayed correctly even after adjusting in step
3 above, perform the adjustments according to the procedures on
the following pages. When the screen is displayed correctly, go to
step 5 "To adjust color gradation automatically [AutoRange]".
4
Perform advanced adjustments by using
adjustment menu.
Select (Manual) to adjust the clock, phase and position, in this order.
●
To eliminate vertical bars [Clock]
(1) Adjust the clock with
vertical bars.
● To remove flickering or blurring [Phase]
(1) Adjust the phase with
flickering or blurring.
(Undo), the monitor returns to the pre-adjusted status.
or of
or of
(OK).
(Manual) in the
(Clock) to eliminate
(Phase) to remove
Chapter 2 Settings and Adjustments
NOTE NOTE
• Press the control button slowly so as • Press the control button slowly so as
not to miss the adjustment point. not to miss the adjustment point.
• When blurring, flickering or bars • When blurring, flickering or bars
appear on the screen after adjustment, appear on the screen after adjustment,
proceed to [Phase] to remove proceed to [Phase] to remove
flickering or blurring. flickering or blurring.
Attention Attention
• Flickering or blurring may not be • Flickering or blurring may not be
eliminated depending on your PC or eliminated depending on your PC or
graphics board. graphics board.
11