Wiring The Dc Power Supply - Cisco CISCO2515-RF - 2515 Router User Manual

Wiring the DC Power Supply

If you ordered a router with a DC power supply, follow the directions in this section to wire
the terminal block.
Warning
removed from the DC circuit. To ensure that all power is OFF, locate the circuit breaker on
the panel board that services the DC circuit, switch the circuit breaker to the OFF position,
and tape the switch handle of the circuit breaker in the OFF position. (To see translated
versions of this warning, refer to the Regulatory Compliance and Safety Information
document that accompanied your router.)
Note
use with 14 AWG copper conductors only. The installation must comply with all applicable
codes.
Take the following steps to wire the terminal block:
Step 1
Step 2
Warning
supply using the appropriate lugs at the wiring end, as illustrated. The proper wiring
sequence is ground to ground, positive to positive (line to L), and negative to negative
(neutral to N). Note that the ground wire should always be connected first and disconnected
last. (To see translated versions of this warning, refer to the Regulatory Compliance and
Safety Information document that accompanied your router.)
Before performing any of the following procedures, ensure that power is
This product is intended for installation in restricted access areas and is approved for
Attach the appropriate lugs at the wire end of the power supply cord.
Wire the DC power supply to the terminal block, as shown in Figure 3-10.
The illustration shows the DC power supply terminal block. Wire the DC power
Connecting the DC Power Supply
Installing the Router 3-11