Verifying Network Connectivity; Getting More Information - Cisco CISCO2515-RF - 2515 Router User Manual

Verifying Network Connectivity

After you have installed and configured the router, you can use the following commands in
user EXEC mode to verify network connectivity:
•
telnet—Logs in to a remote node
•
ping—Sends a special datagram to the destination device, then waits for a reply
datagram from that device
•
trace—Discovers the routes that packets take when traveling from one router to another
If there is a problem with network connectivity, refer to the section "Reading the LEDs" in
the appendix "Troubleshooting the Router" and check the cable connections. If there is still
a problem, check the router configuration.

Getting More Information

For more information about router software configuration, refer to the Cisco IOS
configuration guide and command reference publications. These publications are available
on the documentation CD that accompanied your router or you can order printed copies.
Refer to the section "Ordering Documentation" in the "Overview of the Router" chapter for
ordering information.
Verifying Network Connectivity
Configuring the Router 4-23