Cisco 7604-RSP720C-R Configuration Manual page 25

S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - d o c f e e d b a c k @ c i s c o . c o m
Configuring Basic Interface Parameters
This chapter describes how to configure the basic interface parameters on Cisco NX-OS devices.
This chapter includes the following sections:
Information About the Basic Interface Parameters, page 2-2
•
• Licensing Requirements, page 2-12
• Guidelines and Limitations, page 2-13
• Default Settings, page 2-14
Configuring the Basic Interface Parameters, page 2-14
•
Verifying the Basic Interface Parameters, page 2-54
•
Monitoring the Interface Counters, page 2-54
•
Feature History for Configuring Basic Interface Parameters, page 2-57
•
To configure the parameters that are specifically used for Layer 2 interfaces (access or trunking
Note
interfaces), see
specifically used for Layer 3 interfaces (routed interfaces, subinterfaces, VLAN interfaces, loopback
interfaces, and IP tunnels), see
OL-23435-03
Chapter 3, "Configuring Layer 2 Interfaces."
Chapter 4, "Configuring Layer 3 Interfaces."
Cisco Nexus 7000 Series NX-OS Interfaces Configuration Guide, Release 5.x
2
C H A P T E R
To configure parameters that are
2-1