Checking The Configuration Compatibility On A Vpc Peer Link - Cisco 7604-RSP720C-R Configuration Manual

Configuring vPCs
S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - d o c f e e d b a c k @ c i s c o . c o m
3.
4.
5.
DETAILED STEPS
Command
Step 1
configure terminal
Example:
switch# configure terminal
switch(config)#
Step 2
vpc domain domain-id
Example:
switch(config-if)# vpc domain 5
switch(config-vpc-domain)#
Step 3
graceful consistency-check
Example:
switch(config-vpc-domain)# graceful
consistency-check
Step 4
exit
Example:
switch(config-vpc-domain)# exit
switch(config)#
Step 5
show vpc brief
Example:
switch# show vpc brief
This example shows how to enable the graceful consistency check feature:
switch# configure terminal
switch(config)# vpc domain 5
switch(config-vpc-domain)# graceful consistency-check

Checking the Configuration Compatibility on a vPC Peer Link

After you have configured the vPC peer link on both vPC peer devices, check that the configurations are
consistent on all vPC interfaces. See the
page 7-15
SUMMARY STEPS
1.
2.
Cisco Nexus 7000 Series NX-OS Interfaces Configuration Guide, Release 5.x
7-40
graceful consistency-check
exit
(Optional) show vpc brief
for information on consistent configurations on the vPCs.
configure terminal
(Optional) show vpc consistency-parameters {global | interface port-channel channel-number}
Purpose
Enters global configuration mode.
Creates a vPC domain if it does not already exist,
and enters the vpc-domain configuration mode.
Specifies that only the links on the secondary peer
device are suspended when a mismatch is detected in
a mandatory compatibility parameter.
Use the no form of this command to disable the
feature.
Exits the vpc-domain configuration mode.
(Optional) Displays information on the vPCs.
"Compatibility Parameters for vPC Interfaces" section on
Chapter 7 Configuring vPCs
OL-23435-03