E1 Channelized Mode - Cisco 2620 Configuration Manual

Configuring Interface Parameters
Configuring the PRI D-channel
Would you like to enable multilink PPP? [yes]:
Configure IP on this interface? [no]: y
Configure IP unnumbered on this interface? [no]: y
All users dialing in through the PRI will need to be
authenticated using CHAP. The username and password are
case sensitive.
Enter more username and passwords for PPP authentication? [no]: y
Enter the username used for dial-in CHAP authentication [Router]:
of the user dialling in on PRI:
Enter more username and passwords for PPP authentication? [no]:

E1 Channelized Mode

The following is an example of an E1 channelized mode configuration using the setup command facility:
The following framing types are available:
Enter the framing type [crc4]:
The following linecode types are available:
Enter the line code type [hdb3]:
Do you want to configure Serial1/1:0 interface?: [Yes]:
Configuring the Channelized E1/T1 serial channels
Some encapsulations supported are
Choose encapsulation type
Configure IP on this interface? [no]: y
Configure IP unnumbered on this interface? [no]:
IP address for this interface: 3.0.0.1
Subnet mask for this interface [255.0.0.0]:
Class A network is 3.0.0.0, 8 subnet bits; mask is /8
Note
The following sections describe the prompts for each encapsulation type. No further configuration is
needed for HDLC encapsulation.
PPP Encapsulation
Would you like to enable multilink PPP [yes]:
Enter a remote hostname for PPP authentication [Router]:
Enter a password for PPP authentication:
Note
The password, which is used by the Challenge Handshake Authentication Protocol (CHAP)
authentication process, is case sensitive and must match the remote router's password exactly.
Frame Relay Encapsulation
The following lmi-types are available to be set,
when connected to a frame relay switch
Software Configuration Guide for Cisco 2600 Series, Cisco 3600 Series, and Cisco 3700 Series Routers
2-18
Assign to which interface [Ethernet0/0]:
no-crc4 | crc4
ami | hdb3
ppp/hdlc/frame-relay/lapb/atm-dxi/smds/x25
[0] none
[ppp]:
Chapter 2 Using the Setup Command Facility
Enter the PPP password
OL-1957-04