Isdn Bri Line Configuration; Isdn Bri Provisioning By Switch Type - Cisco 2620 Configuration Manual

Chapter 2 Using the Setup Command Facility
X.25 Encapsulation
x25 circuit can be either in dce/dte mode.
Choose from either dce/dte [dte]:
Enter local x25 address: 1234
We will need to map the remote x.25 station's x25 address
to the remote stations IP/IPX address
Do you want to map the remote machine's x25 address to IP address? [yes]:
Do you want to map the remote machine's x25 address to IPX address? [yes]:
Enter remote x25 address: 4321
Enter lowest 2-way channel [1]:
Enter highest 2-way channel [64]:
Enter frame window (K) [7]:
Enter Packet window (W) [2]:
Enter Packet size (must be powers of 2) [128]:

ISDN BRI Line Configuration

Before using a router with an ISDN BRI interface, you must order a correctly configured ISDN BRI line
from your local telecommunications service provider.
The ordering process varies from provider to provider and from country to country. However, here are
some general guidelines:
•
•
•
•

ISDN BRI Provisioning by Switch Type

ISDN BRI provisioning refers to the types of services provided by the ISDN BRI line. Although
provisioning is performed by your ISDN BRI service provider, you must tell the provider what you want.
Table 2-2
OL-1957-04
IP address for the remote interface: 6.0.0.1
IPX address for the remote interface: 40.0060.34c6.90ed
Ask for two channels to be called by one number.
Ask for delivery of calling line identification, also known as caller ID or Automatic Number
Identification (ANI).
If the router will be the only device attached to the ISDN BRI line, ask for point-to-point service
and a data-only line.
If you plan to connect another ISDN device (such as an ISDN telephone) to the ISDN BRI line
through the router, ask for point-to-multipoint service (subaddressing is required) and a
voice-and-data line.
lists the provisioning you should order for the router based on switch type.
Software Configuration Guide for Cisco 2600 Series, Cisco 3600 Series, and Cisco 3700 Series Routers
Configuring Interface Parameters
2-15